hydra paks

[TheSoaker]

So I just picked up 2 hydra paks and I want to know how I could K mod one of them.

[Nitro123PG]

Well, first you need to open your blaster and get to the dual PC's in the Hydra Pak. After than, simply layer 12 inch ballons over each PC. Any party ballons will work. I would start off using a light K-Mod and add 20-30 ballons to see the difference, and than add or remove ballons from there. Light K-mods are also nice since they increase range and output but have little effect in wearing the gun out.

SSC Guide: http://www.sscentral.org/mods/kmod.html

[martianshark]

You could, but it might be difficult to open it.

[TheSoaker]

ok iv'e opened it and are you sure i can get a balloon on this?:

[Nitro123PG]

Yes, you should be able to. Let us know how it works when your done!

[martianshark]

Regular balloons might not fit if it's like my Vanquisher. I used punching balloons on my Vanquisher; it worked pretty well. Remember to use baby powder or you'll never get them on.

[TheSoaker]

ok i got them on but they all snapped off when i pumped it up. any suggestions?

[marauder]

Regular balloons might not fit if it's like my Vanquisher. I used punching balloons on my Vanquisher; it worked pretty well. Remember to use baby powder or you'll never get them on.

How much of a range increase did you get?

[TheSoaker]

about 49 feet with the mid sized nozzle

[martianshark]

Regular balloons might not fit if it's like my Vanquisher. I used punching balloons on my Vanquisher; it worked pretty well. Remember to use baby powder or you'll never get them on.

How much of a range increase did you get?

I'm not sure. I didn't notice much of a range increase, but the output was a lot better. The shot time was incredible since I did a PC expansion (meaning I took out the net thing that was around the PC)