WaterWar.net

Here's an Internal Picture of a Super Soaker Liquidator. While not every single part is pointed to, the main ones are. What do you call/how would you describe a certain part or section identified by the numbers? I'll post up the names I use after a few responses are posted.

Notes:
- if you don't need to come up with a name for a part you are uncertain about. Just give names for the numbers you use specific names for.
- you may need to expand your window to see the whole picture. Parts are numbered based on previous thread.

1. Reservoir cap.
2. Reservoir.
3. Feed line?
6. Pump shaft or pump tube.
8. Pump rod.
9. Pump handle.
10. Don't know what that is. I'm assuming it's the relief valve and the air input place.
15. Firing valve.
16. Firing valve assembly.
17. Trigger
19. Nozzle.

1. Quick Fill Reservoir Cap
2. Reservoir/pressure chamber
3. Air input tube
6. Pump tube
8. Pump
9. Pump Handle
10. Air Input (connects to the pump, just not too visible)
15. firing Valve
16. Max-D trigger system
17. Trigger
19. Nozzle
We seem to be skipping numbers

We seem to be skipping numbers

So you noticed! I tried to keep the numbering identical between this blaster and the previous image, though I'm not sure where #10 is really equivalent to the #10 labeled for the Water Warriors Piranha.

There is no #10 (in theory) in the Piranha, but the closest thing would be the tube that connects the reservoir to the check valves and pump. That would be # 10 (At the back of the gun)

Well, if #10 is what I think it is, it is a pressure relief valve together with the air-input valve. I actually can't physically check on my Liquidator though as it is now in deep storage. It's not exactly what the Water Warriors Piranha has, of course, particularly since the Piranha pumps water, not air. Perhaps it should be given a different number, though. You make a good point.

Isn't the PRV in the pump? That is where they are in other Pressurized Reservoir guns. The Hydroblade has the same pump, just different colours than the Liquidator.