Help with CPS 4100

[Lt.Winters]

Okay, I took off the nozzle off my 4100, and the little orange cone thing fell out with the spring. So I put it back in. But i forgot about the spring so now it's stunk. And now i can't use the nozzle selecter anymore. Any suggestions?

[isoaker]

Still have the spring?

If so, you'll need to get the orange nub out of the hole without doing too much damage to the rounded surface. Take off the nozzle selector, point the soaker downwards, and see if the orange nub will slide out. If not, find a thick book (maybe a phone book) and try lightly hitting/dropping your soaker pointing downwards onto it to try to dislodge the orange nub. Don't drop your soaker from too high or else you'll do damage! You can also try using some tape or needles to try to extract the orange nub from the hole it's stuck in. If you're still unable to dislodge it, pictures of your problem would help us give more specific directions.

Good luck!

[Lt.Winters]

How would i post pictures?

[isoaker]

Re: pictures - If you have webspace, you'd need to upload the image and then link to the picture using the 'Image' button. If you don't have webspace, you can email me the image and I'll put them to a place you can link to in your posts.

[Lt.Winters]

Okay, nothing worked besides the tape solution!!It seems like it was stuck so badly that I've never thought of the tap. :p

[NiborDude]

I had this problem with a CPS 2500. What I did was I drilled a really tiny hole in the back of the part that holds the spring and "button." Then I took a paper clip that was straightened and pushed the button out.